The electrical energy consumed by electronic devices during work, such as rf power amplifier, FPGA chip and power supply products, is mostly converted into heat emission in addition to useful work. The heat generated by the electronic equipment causes the internal temperature to rise rapidly. If the heat is not released in time, the equipment [...]
1) increase the intensity of the radiation electromagnetic field, as well as the spacing or shielding between components with more active electromagnetic induction. 2) try to avoid thick and cloudy bump voltage equipment, strong and weak signal equipment interwoven together. 3) during planning, the cut of the magnetic field line to the printed wire shall [...]
Double-sided circuit board characteristic The difference between a single-sided circuit board and a double-sided circuit board is the number of copper layers. Double-sided circuit board is both sides of the circuit board with copper, can be connected through the hole. Only one layer of copper on the single side can be used for simple lines, [...]
In view of the circuit board factory inventory management system is not perfect, improve the management system. Circuit board factory first need to establish and improve the post responsibility management system, strengthen the dynamic management of warehouse materials. The main businesses in the circuit board factory inventory procurement process include the submission of requisitions, signing [...]
PCB board is one of the most common electronic components, almost all electronic products will use PCB board! PCB is widely used in electronics, computers, electrical appliances, mechanical equipment and other industries, it is the support body of components, mainly used to connect components to provide electrical, which is the most common and widely used [...]
The copper foil is covered throughout the circuit board and is partly etched off during the manufacturing process. The surface can be seen very small line data is copper foil. What's left is a network of tiny wires called wires, or wiring, that provide the electrical connections for the parts on the circuit board. Usually [...]
The red meter pen is grounded, the pin position in the red ring is the location, and the negative pole of the capacitor is the location. The black meter pen is placed on the IC foot to be measured, then the multimeter will display a diode value, according to the value of the diode to [...]
In view of the circuit board factory inventory management system is not perfect, improve the management system. Circuit board factory first need to establish and improve the post responsibility management system, strengthen the dynamic management of warehouse materials. The main businesses in the circuit board factory inventory procurement process include the submission of requisitions, signing [...]
The 2019 international electronic circuit (shenzhen) exhibition themed "convergence, innovation and navigation" was held at shenzhen convention and exhibition center on Dec. 4. The exhibition, co-organized by the Hong Kong circuit board association and the China electronic circuit industry association, covered 68,900 square metres, with 621 exhibitors and 3,537 booths, showcasing innovative products and technologies [...]
It can be seen from the external packaging mode that the SMT inductor has no pin; The plug-in inductor obviously has a very long pin; Although the plug-in inductance has obvious advantages in cost; But the power inductor of SMT can reduce the manual of plug-in; The maximum advantage patch power inductor has no pins; [...]